Improved productivity with access to accurate, automatic production and volume reports.Ability to monitor where material was removed and dropped.Quickly-defined optimal haul zones using Business Center – HCE.Real-time visibility of cost to move material, load times, and other vital production data.33% project time reduction and 25% hauling productivity gain through transparency of payloads.Georgiou saw benefits in the following areas Georgiou used Business Center – Heavy Construction Edition (HCE) software for Mass Haul Analysis and Design Creation. Data from this hardware was used by InsightHQ and VisionLink® software to improve productivity, increase data transparency and accuracy, and therefore reduce costs. On this project, the team adopted a range of Trimble® solutions including: the 3D GCS900 Grade Control System, 2D Project Monitoring on Haul assets and LOADRITE X2350 excavator scales. They had no access to real-time data on productivity and material movement leading to potentially inaccurate and sometimes delayed information. In the past, Georgiou manually collected payload data to map to cost centres. To get a better understanding of payloads, movement of material, and the productivity of operators and mass haul routes, Georgiou turned to SITECH WA. The site measured 2 kilometers long by approximately 600 meters wide. The six-month project in Alkimos, Western Australia, involved moving 600,000 cubic meters of sand, rock and limestone 1.5 kilometers between the cut and fill zones. When Georgiu Group, a national building construction, engineering and property development company, were awarded a land development project, they took this opportunity to review their productivity and cost control. MinStaff picked it up easily and were away. However, with the simplicity and performance of Perspective, this wasn’t necessary.
And, given this project was mid-COVID and no face-to-face training was available SITECH and UPG were set up and ready to run the project remotely.
Kieran Dinuzzo, Technical Consultant had no doubts when looking at the project that the Trimble X7 and Perspective Software was a perfect fit based on the ability to have a registered, refined, colourised point-cloud ready to bring straight into Trimble Business Centre, which would instill a lot of confidence in the client in achieving a high-end result. Or with us undertaking hard measurements for floor plans, which wouldn’t have been feasible in terms of cost, time, and data storage constraints.”
“Most projects come with strict budgets and time-lines”, said Jake, “But the X7 has improved the amount and the quality of the data we can provide to our clients, all with a much faster turnaround, than had we used the SX10, which would have done the job but taken a lot longer to do.
0 kommentar(er)
